Clarke ENCORE MAX Manual do Operador descarregar pdf (Página 60)

1-60 CLARKE

ENCORE MAX

TRIO SCRUBBER DIAGNOSTIC CODES CON’T.

Dependent on programming. Recharge batteries immediately.

Possible controller fault. Replace controller if not cleared by disconnecting

batteries for 1 minute.

Throttle in drive position during Incorrect operation of machine. Otherwise, check

switch on. throttle mechanism condition; all wiring on

machine for short circuits or breaks (including

Trio 20-way, LCD 16-way if used, front panel

switches & controls); actual switches & controls.

All 310x codes - probable short Check the Traction, Brush & Vac motor

circuit of output device or wiring- connections on Trio; check wiring from these

can sometimes cause perman- connections down to the motors, also checking

nent Controller fault. wiring all along the way for proper connections

and short circuits. Check for the same on Trio’s

14-way connector, as well as the wiring else

where on the rest of machine. Otherwise, replace

controller.

Possible Controller fault. Replace controller if not cleared by disconnecting

batteries for 1 minute.

Possible Controller fault. Replace controller if not cleared by disconnecting

batteries for 1 minute.

Check wiring for short circuits on Trio’s 20-way

All 70xx codes-Check wiring of connector, the LCD’s 16-way connector (if used)

brake & freewheel switch & wiring to freewheel switch & switch itself. Check

traction motor connection on Trio & wiring from

this connector down to electromagnectic brake on

traction motor, checking connections all the way.

Can be caused by excessive pushing or rolling

down an incline or incorrect operation of machine

Wiring fault on 6-way serial link Check wiring & connections on both Trio & LCD

between Trio & LCD. 6-way connectors.

LCD memory corrupt Disconnect batteries & wait 1 minute before

reapplying power.

Open circuit on brush motors or Check brush motor connection to Trio & wiring

brush motor wiring from this connector down to brush motor, check-

ing connections all the way. Otherwise, possible

brush motor fault.

Soft battery lockout

occurred

No output drive

Tiller displace error

Bridge fault 1

Traction bridge fault

Brush/Vac bridge

fault

Soft waiting for

bridge to charge

Traction bridge

fault 2

Bridge fault 2

Minefield mismatch

No internal timers

Internal timer out

of range

A to D readings not

finished before next

read

Unknown mux

channel

ADC module not

ready error

Test trip latch 1

Test trip latch 2

Test trip latch 3

Test trip latch 8

Test trip latch 9

Test trip latch 10

Test trip latch 11

Test trip latch 12

Test trip latch 13

Test trip latch 14

Startup with push

activiated

Push activated in

drive mode

CODE PGDT TECHNICAL PROBABLE CAUSE SERVICE ACTION

DESCRIPTION

LCD module

communications

timeout

LCD module settings

corrupt

Soft brush motor

disconnected error

1 2 ... 55 56 57 58 59 60 61

Comentários a estes Manuais

Sem comentários

Clarke ENCORE MAX Manual do Operador Página 60

Comentários a estes Manuais

Manuais e produtos relacionados com Máquina de piso Clarke ENCORE MAX