Clarke ENCORE MAX Manual do Operador descarregar pdf (Página 44)

1-44 CLARKE

ENCORE MAX

DISK SCRUB BRUSH

SQUEEGEE PIN

SIDE SQUEEGEE

BRUSH BRISTLES

SHOULD NOT

BE LESS THAN

3/4” HIGH

DISK SCRUB BUSHES

REPLACING THE SCRUB BRUSHES

Replace Scrub Brushes when the bristles become worn to 3/4" as shown in figure 56 and 57.

1. Lower scrub brushes.

2. Swing open side squeegees

3. Lift scrub brushes

4. The scrub brush is held in place by a ring. Pull the brush straight down to remove it.

5. Push a new brush onto the scrub brush driver until it clicks in place.

6. Lower Scrub Deck to the NORMAL position and check the brush for proper floor contact.

7. Replace side squeegees.

REPLACING PADS ON A PAD DRIVER

Install a new pad when the old pad is worn or dirty. The pad driver assembly is removed and installed the same

way a standard scrub brush is. (See replacing the scrub brushes) To change pad follow this procedure.

1. The pad driver is held in place by a ring. Pull the pad driver straight down to remove it.

2. Remove the pad holder using the spring wire retainer.

3. Replace the worn pad.

Fig. 56

Fig. 57

MAINTENANCE

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 60 61

Sem comentários

Clarke ENCORE MAX Manual do Operador Página 44