Clarke Clean Track L18 Especificações descarregar pdf (Página 16)

A-16 / ENGLISH

A-16 - FORM NO. 56041660 - Clean Track

16, 18

AUTHORIZED PERSONNEL MAINTENANCE

BRUSH MOTOR REMOVAL

1 Drain the recovery and solution tanks and tip the machine over onto its side.

2 See Figure 8. Remove the (2) (A) Screws.

3 Tip the machine back upright, grab hold of the Operator’s Handle (1) and push down to tilt the entire recovery / solution tank assembly back.

4 See Figure 12. Remove the (3) (A) Screws and then remove the Belt Guard (B).

5 Remove the Belt from the motor pulley and then remove the (4) (C) Screws and Washers.

6 Disconnect the brush motor wiring and remove the Brush Motor (D) from the machine. NOTE: Make note of wire connection locations for

reassembly.

7 Follow the above steps in reverse order to install the brush motor. NOTE: Refer to Instruction Sheet 56040906 for belt installation instructions.

FIGURE 12

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 79 80

Sem comentários

Clarke Clean Track L18 Especificações Página 16