Clarke Clean Track L18 Especificações descarregar pdf (Página 11)

ENGLISH / A-11

FORM NO. 56041660 - Clean Track

16, 18 - A-11

SPRAY NOZZLE MAINTENANCE

Remove the Spray Nozzles (A) once a week. See Figure 7. Soak the nozzles overnight in vinegar to remove chemical deposits. NOTE: Remove

by gripping and turning a quarter turn counter-clockwise.

SOLUTION SCREEN MAINTENANCE

Once a week (or more often if necessary), clean the Solution Screen (6). Drain the solution tank. Open the Solution Tank Lid (5), reach inside the

solution tank and pull up on the solution ﬁ lter to remove.

POWER CORD MAINTENANCE

Once a week (or more often if necessary), check the power cord for cracked or damaged insulation, exposed wires in the cord or plug, and damaged

or missing ground pin. Repair or replace damaged cord or plug immediately.

ADJUSTING THE BRUSH PRESSURE

Simply turn the Brush Pressure Adjustment Knob (20) clockwise to increase brush pressure and counter-clockwise to decrease the brush pressure.

POWER BRUSH MAINTENANCE

Check the brush daily. Remove any built-up string, hair or carpet ﬁ bers. When the machine is not in use it should be placed in the storage position.

This will prevent the brush from taking a set which will increase the brush life and maintain the performance of the brush.

REMOVING THE BRUSH

CAUTION!

Turn the power switch off (O) and unplug the machine, before changing the brush.

FIGURE 7

1 Empty both the recovery and solution tanks and tip the machine over onto its right

side.

2 See Figure 7. Rotate the brush until the Drive Lug (B) is in a position where the

ﬁ ns on the drive lug are perpendicular to the bottom of the machine.

3 Grab the brush at the end with the Brush Retainer Clip (C) and pull straight out.

4 Install a new brush at the drive lug end ﬁ rst then push in the other brush end in until

it snaps into the retainer clip.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 79 80

Sem comentários

Clarke Clean Track L18 Especificações Página 11