Clarke CTS12 Especificações descarregar pdf (Página 25)

ADJUSTING 90 AND 45 DEGREE POSITIVE STOPS

Fig.35

Fig.36

WARNING!

ENSURE THE PLUG IS DISCONNECTED FROM THE POWER SUPPLY BEFORE PROCEEDING

ADJUSTING THE POSITIVE STOPS

1. Raise the blade to maximum height.

2. Turn machine so that it rests on the table top’s

side edge and is supported in some way,

ensuring it is stable.

3. Remove the bottom grill by removing the 6

screws shown.

4. Adjust the Positive stops, indicated in Fig. 35, as

required, checking the blade angle using a set

square and protractor as necessary.

5. When completely satisfied, ensure the stops are

properly locked, then replace the bottom grille.

RENEWING MOTOR BRUSHES

1. Turn machine so that it rests on the table top’s side

edge and is supported in some way, ensuring it is

stable.

2. Remove bottom grille.

3. Unscrew and remove the Brush Caps, (one either side

of the motor housing), then withdraw the brush with

springs attached.

4. Carefully insert replacement brushes and replace the

screw on caps.

Fig.34

NOTE: Always replace both brushes at the same time.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Sem comentários

Clarke CTS12 Especificações Página 25