Clarke CBS 355 Especificações

360mm (14")BAND SAWOperating and MaintenanceInstructionsModel No. CBS 355Part No. 6460080360mm (14")BAND SAW1003

MOTORA ball bearing induction motor is fitted to the bandsaw, powerful enough for all your operating needs.SAWDUST EXTRACTION OUTLETIt is not essentia

OPERATION111 1200 SandingWoodCuttingHardWoodCuttingMetres / min2 7503 1601. Turn the key to ‘I’2. “START”: Push the button marked with “1”.3. “STOP”:

CHANGING BLADES12Lower blade guide block6. Using the hex key supplied, turn the bladetensioning bolt clockwise until it is loose, then turnthe trackin

13USE OF ACCESSORIESCIRCLE CUTTING ATTACHMENTThe circle cutting attachment mounts on the armof the upper guide block. Accurate circles can becut with

POWER DISC SANDER14The sanding table is ribbed in the same way as the bandsaw work table, to keep saw dust below theworking level. The sanding table i

MAINTENANCEBEFORE CARRYING OUT ANY SERVICING OR MAINTENANCE, DISCONNECT THE MACHINE FROM THEPOWER SUPPLYCHANGING TYRESEventually the rubber tyres on t

16FREEHAND SAWINGThe ease with which many different and varied shapes can be cut is one of the most important featuresof the bandsaw. Select a blade s

Item Description Part No.1 Frame FM3550012 Wheel Support FM3550023 Axle Block FM3550034 Pin FM3550045 Bolt FM3550056 Washer FM3550067 Nut FM3550078 Te

SPARE PARTS DIAGRAM18

SANDING BELT ATTACHMENTItem Description Part No.107 Lock Knob FM355107108 Flat Plate FM355108109 Rounded Plate FM355109CIRCLE CUTTING ATTACHMENTItem D

2For Spare Parts and Service, please contact your nearest dealer,or CLARKE International, on one of the following numbers.PARTS & SERVICE TEL: 02

Thank you for purchasing this CLARKE Bandsaw and Sander.Before attempting to operate the machine, please read this instruction manual thoroughly, and

GENERAL SAFETY RULES FOR OPERATING MACHINERYDON’T OVERREACH.Keep your proper footing and balance at all times.For best footing, wear rubber soledfoot

MAINTAIN MACHINE IN TOPCONDITION.Keep tools sharp and cleanfor the best and safestperformance. Followmaintenance instructions.READ and BECOME FAMILIAR

• Use a Push Stick or scrap of wood to do the pushing and guiding, when sawing small pieceswhich require the fingers to be close to the blade.• Set th

POWER SUPPLY7Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13 ampBS 1363 plug, or a suitably fused isola

8MAIN COMPONENTS1. Power ON/OFF switch lock2. No volt switch3. Drive wheel4. Sanding disc5. Motor pulley6. Idler wheel7 Lower blade guides8. Upper bla

1. Remove the table lock knob (A), spring (B)and spring support bush (C) from the tablesupport at the rear of the bandsaw. (Fig.3).2. Remove the hex.