Clarke CTS10PLM Manual de Instruções descarregar pdf (Página 20)

CAUTION!

NEVER use the rip fence as a length stop because the cut-off piece could bind

between the fence and the blade causing a kickback.

6. Mitre Cutting

Mitre cutting is the term used for cutting at an

angle other than 90

to the edge of the wood.

Follow the same procedure as you would for

crosscutting.

Adjust the mitre gauge to the desired angle,

and lock it.

The mitre gauge may be used in either of the

grooves in the table.

When using the mitre gauge in the LEFT hand

groove, hold the workpiece firmly against the

mitre gauge head with your LEFT HAND, and

grip the lock knob with your right.

When using the RIGHT hand groove, hold the

workpiece with your RIGHT HAND and the lock

knob with your left hand,

8. Compound Mitre Cutting

Compound mitre cutting is a combination of mitre cutting and bevel crosscutting. The cut is made at

an angle other than 90

to both the edge and the broad side of the wood.

Adjust the mitre gauge and the blade to the desired angle, and ensure the mitre gauge body is

locked.

CAUTION!

When Mitre cutting, an area of blade is exposed.

Great care must be taken when using the machine for this operation.

Fig.22

Fig.23

7. Bevel Crosscutting

Bevel crosscutting is the same as crosscutting

except that the wood is also cut at an angle,

other than 90

with the broad side of the wood.

Adjust the blade to the desired angle.

Use the Mitre Gauge in the groove to the RIGHT

of the blade. It cannot be used in the groove

on the LEFT because the blade guard will

interfere. Hold the workplece with your right

hand and the lock knob with your left hand.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Sem comentários

Clarke CTS10PLM Manual de Instruções Página 20