Clarke Fusion 201 Manual do Operador descarregar pdf (Página 12)

Page -12- Clarke

Operator's Manual -Fusion 27 Battery Burnisher

HOW TO OPERATE THE MACHINE

HOW TO PREPARE THE MACHINE FOR OPERATION

How To Install The Pad

To install the pad on the machine, follow this procedure:

1. Position the pad centered on the pad driver.

See figure 6

2. Install and tighten the pad retainer.

How To Remove The Pad

To remove the pad on the machine, follow this procedure:

1. Loosen and remove the pad retainer.

2. Pull the pad from the pad driver. See figure 7.

Retainer

Pad Pressure Operation

In order to maintain the amount of "pad pressure" being

applied to the floor, this machine comes with:

1. Pad Presssure Meter - "10 Bar" LED, (2)

Yellow, (6) Green and (2) Red. This is located on

the upper right side of the control panel. See

figure 8.

2. 90 amp circuit breaker

3. Pad Pressure adjustment nut

The color bands on the pad pressure meter indicate

whether the pad pressure is too low (Yellow); within

recommended pad motor specifications (Green); or too

high (Red). If the machine is operating in the Red band

for more than 5 - 10 seconds, the circuit breaker will

"pop", indicating that the pressure on the floor has

exceeded the pad motor specifications. Excessive

"popping" (or blowing) of the circuit breaker will cause the

breaker to stop functioning and will need to be replaced.

This machine operates on a "Pivot-Control" system. This

allows for the machine to "float" along the floor consis-

tently and continues to burnish the floor as the pad

wears. When the pad pressure meter starts to operate in

the Yellow band, it is recommended that the pad be

checked for excessive wear and possible replacement.

If the machine operates in the (Red) band for more than 2-

3 seconds, it is recommended that you reduce the

amount of pad pressure being applied to the floor. Refer

to the "Pad Pressure Adjustment" instructions.

Figure #6

Figure #7

Figure #8

Pad Pressure

Meter

Yellow

Green

Red

Factory

Setting

Recommended

Setting

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Comentários a estes Manuais

Sem comentários

Clarke Fusion 201 Manual do Operador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Máquina de piso Clarke Fusion 201