Clarke Fusion 201 Manual do Operador descarregar pdf (Página 11)

Clarke

Operator's Manual - Fusion 27 Battery Burnisher - 11 -

CAUTION: Irreversible damage will occur to

the batteries if the electrolyte level

does not cover the plates. Keep the

electrolyte at the correct level.

3. Reinstall the caps.

4. After charging, top off the batteries. NOTE: USE

DISTILLED WATER ONLY. THIS SHOULD BE

DONE AFTER CHARGING. The maximum level is

within 1/4 inch of the bottom of the tube in each cell.

See figure 5 B. For instructions on how to charge the

batteries, see "How To Charge The Batteries" below.

CAUTION: Machine damage and discharge

across the tops of the batteries can

occur if the batteries are filled

above the bottom of the tube in

each cell. Do not fill the batteries

up to the bottom of the tube in each

cell. Wipe any acid from the

machine or the tops of the batter-

ies. Never add acid to a battery

after installation.

CAUTION: Tap water may contain contami-

nants that will damage batteries.

Batteries must be re-filled with dis-

tilled water only.

5. Keep the tops of the batteries clean and dry.

Keep the terminals and connectors clean. To clean the

top of the batteries, use a damp cloth with a weak

solution of ammonia or bicarbonate of soda solution.

To clean the terminals and connectors, use a terminal

and connector cleaning tool. Do not allow ammonia or

bicarbonate of soda to get into batteries.

6. Keep the batteries charged.

How To Charge The Batteries

WARNING: Charging the batteries in an area

without adequate ventilation

could result in an explosion. To

prevent an explosion, charge the

batteries only in an area with good

ventilation.

WARNING: Lead acid batteries generate

gases which could explode. Keep

sparks and flames away from bat-

teries. NO SMOKING!

To charge the batteries, follow this procedure:

1. Make sure the key switch is in the “OFF” position.

2. Connect the charger to a properly grounded single

phase (3-wire) wall receptacle having the voltage,

frequency, and ampere capacity specified on the

nameplate of the charger.

HOW TO PREPARE THE MACHINE FOR OPERATION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comentários a estes Manuais

Sem comentários

Clarke Fusion 201 Manual do Operador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Máquina de piso Clarke Fusion 201