Clarke CLS400 Especificações descarregar pdf (Página 5)

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

PRECAUTIONS SPECIFIC TO CIRCULAR SAWS

1. ALWAYS wear ear protectors/defenders during continuous use as the noise

level of this machine can exceed 85dB (A).

2. ALWAYS keep the mains cable well away from the saw and ensure an

adequate electrical supply is close at hand so that the operation is not

restricted by the length of the cable.

3. ALWAYS use only the correct blade for this saw and ensure the blade is

fully tightened before use. The blade must always be rated to operate at

a rotational speed equal to, or greater than that of the machine.

4. Beware of foreign objects. When cutting pre-used wood, ensure all nails

have been removed beforehand. Nails will damage the saw blade.

5. Switching off. Remember that the blade will continue to rotate for a short

time after the stop button has been pressed to stop the saw.

6. NEVER operate the saw when the moving blade guard is not working

properly. The guard should be checked for correct operation before

each use. It must move freely and readily return to the starting position.

7. NEVER operate the saw without the removable blade guard being

installed correctly.

8. NEVER start the saw when the blade is in contact with the work.

9. DO NOT use the saw if the power cable, plug or motor is in poor condition.

10. ALWAYS hold the workpiece securely when cutting. The workpiece should

always be placed securely in the log cradle to avoid loss of control.

11. ALWAYS hold the cradle handles with both hands to keep hands well away

from the saw blade.

12. Do not attempt to saw very small logs including those which cannot be

properly secured.

CHANGING BLADES

1. Unplug the saw from the power supply before changing blades, and take

care to prevent entrapment of the fingers between the blade and the

inner guard. Ensure the blade is secure before use.

2. Use the appropriate saw blade for this saw. Correct blades are available

from your Clarke dealer, (part number 3401992).

3. Only use saw blades in good working condition. Discard and replace

cracked or bent saw blades.

Please keep these instructions in a safe place for future reference.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sem comentários

Clarke CLS400 Especificações Página 5