Clarke CLS400 Especificações descarregar pdf (Página 11)

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

5. Connect the two halves of the

Moving Guard together using the

two short machine screws

together with the flat and spring

washer which should be found

already fitted to one half of the

guard.

6. Lift up the Log Cradle and attach

the Moving Guard to it with 4 x M6

x 12 socket headed screws as

shown in Fig 6. Check that the

Log Cradle and Moving Guard hinge freely.

INSTALLING THE SAW BLADE

FIXINGS REQUIRED:

1 x M20 Nut

1 x M20 Flat Washer

4 x M6 x 45 Bolts with locknuts (attached to the Removable Guard)

1. Install the inner Retaining Disc,

saw blade and outer Retaining

Disc on the motor shaft and

secure them with the flat washer

and 30 mm nut.

• Install the blade in the orientation

shown in fig 7. Do not use a blade

with no markings, but if they have

become worn away during

previous use, inspect the blade

and note the position of the

cutting teeth. The teeth must face

in the direction of rotation as

shown when viewed from the

exposed side.

• Never use cracked, blunt or

otherwise damaged blades.

• Ensure that the blade used is

rated at least equal to the speed/

performance of the machine.

Note that the blade is designed to

sit on a machined shoulder on the

drive shaft and must be in this position before the securing nut is tightened.

2. Use the Blade Locking Wrench to stop the blade from turning while

tightening the nut with the open wrench provided as shown in Fig 8.

Fixed

Guard

Moving

Guard

Guide

Plate

Fig 6

Log

Cradle

Fig 8Open Wrench

Blade

Locking

Wrench

Correct

direction

of rotation

Outer

Retaining Disc

Fig 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comentários a estes Manuais

Sem comentários

Clarke CLS400 Especificações Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares Clarke CLS400