Clarke CDP151B Manual de Instruções Página 1

0307SERIAL No...

E. Installing the Chuck.1. Slide the work table up the column to within 6" of thespindle.2. Open the jaws of the chuck to their maximum, usingthe

SETTINGS and ADJUSTMENTSA bevel scale is provided onthe table mounting,measured in degrees, toassist in setting the requiredangle.For all normal opera

3. Changing Drill (Spindle) Speed.4. When the belt has been correctly positioned, re-tension by levering the motor awayfrom the head, until the belt

OPERATION.1 . Insert the drill bit into the jaws of the chuck by approx 1", ensuring that the jaws do nottouch the flutes of the drill. Before ti

2480 1670 1130 730 460in 3/8 1/2 - - -mm 9.5 12.5 - - -in 7/32 11/32 15/32 - -mm 5.6 8.75 12 - -in 3/32 5/32 1/4 3/8 1/2mm 2.4 4 6.4 9.5 12.5MAINTENAN

TROUBLE SHOOTING Excessive drill wobbleA) Loose chuckB) Worn spindle, or bearingC) Worn chuckD) Bent drillA) Tighten by pressing chuck down onto a b

PULLEY ASSEMBLY16Item Description Part No. Item Description Part No1 Knob DD161050082 Pan Head Screw M5 30406563 Motor Pulley DD132050054 Hex Skt Scre

Item Description Part No1 Column DD132010022 Hex. Head Screw M8 30405013 Base DD132010014 Table Tilt Locking Screw 30405105 Table Support w/Scale DD1

HEAD ASSEMBLYItem Description Part No. Item Description Part No1 Head w/Pointer and Trim DD132020012 Motor Assembly DDYYG71L4(W)3 Hex. Nut M8 30406014

SPECIFICATIONSMotor ... 230VAC, 50Hz, 1 PhasePower Rating ...

When disposing of this product, do not dispose of with general waste. It must be disposed of according to law ata recognised disposal facility.2

INTRODUCTIONThank you for purchasing your CLARKE - CDP 151B, 13mm bench mounted DrillPress.Before attempting to operate the machine, please read this

GENERAL SAFETY PRECAUTIONSWARNINGAs with all machinery, there are certain hazards involved with their operationand use. Exercising respect and caution

19. DO NOT STAND ON THE MACHINE. Serious injury could occur if the machine is tippedover. Do not store materials above or near the machine such that i

ELECTRICAL CONNECTIONSConnect the mains lead to a standard, 230 Volt (50Hz) electrical supply through anapproved 13 amp BS 1363 plug, or a suitably fu

PREPARATIONOn receipt, carefully unpack the components, ensuring that no damage was suffered intransit, and that all parts are accounted for.The follo

Remove all traces of preservative from the components with paraffin or a good qualitysolvent, and wipe all parts thoroughly with a clean dry cloth. Ap

ASSEMBLYCAUTION!IT IS ADVISED THAT ASSISTANCE BE USED WHEN ASSEMBLING THIS MACHINE.A. Column to the Base.C. Head to Column.NOTE: It may be necessary t