Clarke FG2000 Especificações descarregar pdf (Página 10)

Wiring instructions for the Clark • Reliance GL53 Illuminators

(for 'C' and 'S' Series Gages).

Note: Make sure that the power is turned off to the supply wiring

before connecting the illuminator.

Tools needed:

– Slotted Screwdriver

– 1/2" Wrench

1. Open the illuminator housing by loosening the three hex head cap

screws on the end of the unit that secures the Conduit/Lamp

assembly in place.

2. Carefully remove the assembly and remove the 60W Frosted

Lamp (B) from the illuminator housing and set aside.

3. Loosen the screw (C) from the side of the lamp socket/conduit

connector that holds the assembly in place on the pipe nipple.

4. Take the lamp socket/conduit connector assembly (D) off of the

housing end piece and set the housing aside.

5. Disassemble the lamp socket/conduit connection assembly by

removing the two screws (E) from inside of the lamp socket. (Note

that there are two small washers on the assembly screws. Do not

lose these washers as they are needed for re-assembling the

illuminator.)

7. Connect the black wire to the ‘gold’ screw terminal on the bottom

of the lamp socket.

8. Connect the white wire to the ‘silver’screw terminal on the bottom

of the lamp socket.

9. Re-assemble the lamp socket/conduit connector assembly using

the same two screws with washers inside of the lamp socket. Make

sure that the mounting plate is centered on the lamp socket/conduit

connector assembly.

10. Thread the lamp socket/conduit connector assembly back into

the bottom of the pipe nipple and tighten the holding screw.

11. Carefully screw the lamp into the socket and re-assemble the

bottom assembly back onto the illuminator housing (make sure that

the gasket between the bottom assembly and housing is in place).

Secure by tightening the three hex head cap screws on the bottom

side of the housing.

12. Wire the illuminator to the 120 V.* power supply. (*Unless lamp is

for 230 V. service) Note that a proper ground wire is recommended.

GL53 Illuminator - 120V.

Specification:60W/120V

Current Draw: .5 Amps

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Clarke FG2000 Especificações Página 10