Clarke Bext-100H Manual do Operador descarregar pdf

BEXT 100H Extractor

Operation and Safety

Safety Practices:

Machine can cause an

explosion when operated

near flammable material

and vapors. Do not use

this machine with or near

fuels, grain dust, solvents,

thinners or other

flammable materials.

Always use a 3- wire

electrical system

connected to the electrical

ground.

Keep hands, feet, and

loose clothing away from

all moving parts on the

machine.

Remove the electrical plug

from the electrical outlet

before doing any repairs or

maintenance to this

machine.

Never leave the machine

unattended while it is

connected to a power

source.

It is recommended that

you use liquid cleaning

chemicals. Powder can

damage the machine.

Do not use water that is

hotter than 120°F (40° C).

www.clarkeus.com/rental

More on reverse….

Application: Easily extract large or confined carpeted areas such as

stairs or tight office spaces. Use optional hand tool when cleaning

partition, fabrics and upholstery.

Set-up and operation

Follow the steps below to successfully use extractor:

Step Action

To set-up machine:

a.) Connect vacuum hose to the

hose connector on the

extractor (1) and to the end of

the vacuum tube on the floor

tool (2).

b.) Connect the solution hose (3)

to the extractor and the floor

tool (4).

c.) Put clean hot water into the

solution tank (5).

d.) Add a cleaning chemical to the

hot water (for amount see

container).

e.) Plug in cord #1 (identified by

red “H” on the end).

f.) Turn pump on (6) and set the

switch to “Upholstery” setting.

Run till pump is fully primed

and then turn off pump.

g.) Remove the priming hose and

attach the cleaning hose & tool.

h.) Turn on the pump and spray

through the cleaning tool for a

few seconds to fill line with

solution.

i.) Plug in cord #2. The “locator

light” (7) will light up when the

cords are plugged into

separate circuits.

j.) Turn “heat” switch on and wait

2 minutes to reach operating

temperature.

k.) Begin cleaning (see steps 2

and 3).

NOTE: The “mode” light will turn

on when the heat exchanger is

actively heating.

NOTE: If the “locator” light does not

light when cord #2 is plugged in, try

another outlet until it does come on.

1 2

Resumo do Conteúdo

Página 1 - BEXT 100H Extractor

BEXT 100H Extractor Operation and Safety Safety Practices: Machine can cause an explosion when operated near flammable material and vapors. Do

Página 2 - BEXT 100 H Extractor

BEXT 100 H Extractor WARNING: If foam liquid comes out, stop extracting immediately. Allow vacuum to run until exhaust is dry. WARNING: We recomm

Comentários a estes Manuais

Sem comentários

Clarke Bext-100H Manual do Operador

Consulte online ou descarregue Manual do Operador para não Clarke Bext-100H. Clarke Bext-100H Operator`s manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com não Clarke Bext-100H